Sirius

Sirius stabilizers are available for different ranges of input voltage ?uctuation. In the ±15%/ ±20% and ±25%/ ±30% types, the change of input range is obtained through different internal connections (only up to 2000kVA ±15% and equivalent). Sirius stabilizers are equipped with columnar voltage regulators which enable the achievement of high ratings (up to 6000kVA) and a solid and reliable construction, thus meeting the most diverse industrial applications. The Sirius voltage stabilizers regulate the output voltage independently on each phase. Similarly to the other models, they can supply any single-phase, bi-phase and three-phase load even in case of and up to 100% unbalanced load current and asymmetrical mains distribution. In any case, the presence of the neutral wire is required. The stabilizer can also operate without neutral wire by adding a device able to generate it (D/zn or D /yn isolating transformer or neutral point reactor). The stabilizers are cooled via natural air ventilation, assisted by extracting fans when the cabinet internal temperature exceeds 35°C. The user interface consists of a multilingual 10" touch panel (?tted with RS485 port) able to provide with information regarding the status of the lines upstream and downstream the voltage stabilizer (phase and linked voltages, current, power factor, active power, apparent power, reactive power, etc.), the operating status of the stabilizer displaying all the information regarding each phase operating mode ('power on'; reaching of voltage regulation limits; increase/decrease of voltage regulation, etc.) and the possible alarms (minimum and maximum voltage, maximum current, overtemperature, etc.). The alarm indicators are accompanied by an acoustic alarm. The display is remotable using VNC software. It is also possible to communicate with the stabilizer with the Modbus TCP/IP protocol (standard communication protocol between electronic industrial equipment) via an Ethernet connection with RJ45 cable. The control system is also provided with two USB ports for downloading stored data and uploading new releases of the control card software. The Sirius stabilizer is provided with an electronic voltage regulator protection system activates in case of overload on the voltage regulator. In such condition the load supply is not interrupted, but the stabilizer output voltage is automatically set to the lower between the mains voltage and the pre-set output voltage. The service continuity is guaranteed, although the voltage is not stabilised. When the overload condition ceases to exist, the stabilizer switches automatically back to regular functioning. The control logic is managed by two DSP microprocessors (one performing the control and the other one managing the measurements) which obtain the output voltage stabilisation by adjusting its true RMS value. The whole system is supervised by a third 'bodyguard' microprocessor that controls the correct functioning of the other microprocessors. The unit parameters and reference output voltage value can be set via a PC connection, allowing for promptly dealing in the ?eld with any issues concerning voltage stability. The output voltage is reset to the minimum value in case of blackout by means of supercapacitor banks in order to ensure the correct shutdown. All Sirius stabilizers are provided with Class I and Class II SPD surge arrestors.